Published since 1923
DOI: 10.33622/0869-7019
Russian Science Citation Index (RSCI) на платформе Web of Science


  • BUILDING MATERIALS AND PRODUCTS
  • The Influence Of Stone Filling On The Work Of Monolithic-Frame Buildings
  • UDC 693.98
    doi: 10.33622/0869-7019.2024.06.74-80
    Ilya A. VOILOKOV1, voilokov@mail.ru
    Roman B. ORLOVICH2, orlowicz@mail.ru
    Alexander S. GORSHKOV3, alsgor@yandex.ru
    1 Saint Petersburg State University of Architecture and Civil Engineering, ul. 2-ya Krasnoarmeiskaya, 4, St. Petersburg 190005, Russian Federation
    2 Institut of Desing GEORECONSTRUKTSIYA, Izmailovsky prospekt, 4, of. 414, St. Petersburg 190005, Russian Federation
    3 Saint Petersburg State University of Industrial Technologies and Design, ul. Bolshaya Morskaya, 18, St. Petersburg 191186, Russian Federation
    Abstract. Reinforced concrete monolithic frame buildings occupy a dominant position in modern housing construction. The spatial rigidity of the reinforced concrete frame, as a rule, is provided by vertical monolithic stiffening diaphragms and floor discs. At the same time, the joint work of the stone filling and the monolithic reinforced concrete frame of the building is often not taken into account. Stone filling is able to resist shear deformations of the frame, thereby increasing its rigidity and bearing capacity. It is established that the participation of stone filling in the work of a monolithic reinforced concrete frame not only significantly increases the spatial rigidity of the building, but also significantly affects the distribution of internal forces in the frame elements. It is shown that the joint work of masonry with the building frame leads to a decrease in internal forces in the vertical elements of the frame and a simultaneous increase in the filling resistance to shear forces and bending. Together, this contributes to increasing the crack resistance of the wall filling and reducing the material consumption of the reinforced concrete frame. The replacement of vertical reinforced concrete stiffening diaphragms with stone filling makes it possible to reduce the overall consumption of concrete and reinforcing steel, reduce the complexity of construction and installation works by by eliminating formwork, reinforcement and concrete work, accelerate the construction time of the building.
    Keywords: monolithic-frame buildings, reinforced concrete frame, spatial rigidity of the building, stone filling of walls, brick, stone, silicate wall blocks, aerated concrete blocks
  • REFERENCES
    1. Polyakov S. V. Kamennaya kladka v karkasnyh zdaniyah [Stone masonry in frame buildings]. Moscow, Gosstroyizdat Publ., 1956. 189 p. (In Russ.).
    2. Polyakov S. V. Sejsmostojkie konstrukcii zdanij [Seismic resistant of building structures]. Moscow, Vysshaya shkola Publ., 1983. 304 p. (In Russ.).
    3. Izmajlov Yu. V. Sejsmostojkost' karkasno-kamennyh zdanij [Seismic resistance of frame-stone buildings]. Kishinev, Kartya Moldovenyaske Publ., 1975. 310 p. (In Russ.).
    4. Diagonal tensile strength tests of small walls specimens. TC76-LUM: RILEM LUMB 6 1991. Bagneux: International Union of Laboratories and Experts in Construction Materials, Systems and Structures, 1991. 2 p.
    5. Hamburger R. O. Methodology for seismic capacity evaluation of steel-frame buildings with infill unreinforced masonry. Proc. National Earthquake Conference, Central U.S. Earthquake Consortium (Memphis, Tennessee, May 2-5, 1993), vol. II, pp. 173-191.
    6. Ishchuk M. K. Otechestvennyj opyt vozvedeniya zdanij s naruzhnymi stenami iz oblegchennoj kladki [Domestic experience in constructing buildings with external walls made of lightweight masonry]. Moscow, RIF Strojmaterialy Publ., 2009. 360 p. (In Russ.). 7. Gorshkov R. A., Rajceva A. R., Vojlokov I. A. Systematic analysis of the causes of damage to facing ceramic bricks. Vestnik Sankt-Peterburgskogo gosudarstvennogo universiteta tekhnologii i dizajna. Seriya 4: Promyshlennye tekhnologii, 2022, no. 2, pp. 106-114. (In Russ.). doi: 10.46418/2619-0729_2022_2_19
    8. Gorshkov A. S. Evaluation of the durability of a wall structure based on laboratory and field tests. Stroitel'nye materialy, 2009, no. 8, pp. 12-17. (In Russ.).
    9. Gorshkov A. S., Knat'ko M. V., Rymkevich P. P. Laboratory and field studies of durability (service life) of a wall structure made of autoclaved aerated concrete with a facing layer of sand-lime brick. Inzhenerno-stroitel'nyj zhurnal, 2009, no. 8(10), pp. 20-26. (In Russ.). doi: 10.18720/MCE.10.3
    10. Gorshkov A. S. Model of physical deterior ation of building structures. Stroitel'nye materialy, oborudovanie, tekhnologii XXI veka, 2014, no. 12(191), pp. 34-37. (In Russ.).
    11. Gorshkov A. S., Popov D. Yu., Glumov A. V. Structural design of a ventilated facade with increased reliability. Inzhenerno-stroitel'nyj zhurnal, 2010, no. 8(18), pp. 5-8. (In Russ.). doi: 10.18720/MCE.18.4
    12. Derkach V. N., Orlovich R. B. On the use of rod models in the calculation of stone filling of frame buildings. Stroitel'stvo i rekonstrukciya, 2011, no. 4(36), pp. 9-13. (In Russ.).
    13. Federal Emergency Management Agency. NEHRP Commentary on the guidelines for the seismic rehabilitation of buildings / FEMA-274. Applied Technology Council. Washington, 1999. 509 p.
    14. Derkach V. N., Orlovich R. B. Bearing capacity of stone filling of frame buildings. Stroitel'stvo i rekonstrukciya, 2011, no. 3(35), pp. 3-8. (In Russ.).
    15. Derkach V. N., Orlovich R. B. Experimental studies of the effect of stone filling on the shear stiffness of building frames. Promyshlennoe i grazhdanskoe stroitel'stvo, 2014, no. 11, pp. 53-57. (In Russ.).
    16. Vatin N. I., Gorshkov A. S., Kornienko S. V., Pestryakov I. I. Consumer properties of wall products made of autoclaved aerated concrete. Stroitel'stvo unikal'nyh zdanij i sooruzhenij, 2016, no. 1(40), pp. 78-101. (In Russ.). doi: 10.18720/CUBS.40.7
    17. Derkach V. N., Gorshkov A. S., Orlovich R. B. Problems of crack resistance of wall filling of frame buildings made of cellular concrete blocks. Stroitel'nye materialy, 2019, no. 3, pp. 52-56. (In Russ.). doi: 10.31659/0585-430X-2019-768-3-52-56
    18. Orlovich R. B., Derkach V. N. Application of classical strength theories to the calculation of masonry under complex stress conditions. Stroitel'stvo i rekonstrukciya, 2011, no. 1(33), pp. 35-40. (In Russ.).
    19. Derkach V. N. Aspects of designing walls of frame-stone buildings with advanced construction of stone filling. Stroitel'naya mekhanika i raschet sooruzhenij, 2021, no. 5, pp. 41-46. (In Russ.).
  • For citation: Voilokov I. A., Orlovich R. B., Gorshkov A. S. The Influence of Stone Filling on the Work of Monolithic-Frame Buildings. Promyshlennoe i grazhdanskoe stroitel'stvo [Industrial and Civil Engineering], 2024, no. 6, pp. 74-80. (In Russ.). doi: 10.33622/0869-7019.2024.06.74-80

BACK